SquareTrade © AP6.0... This is the 1/8 scale glow powered, radio controlled, ready-to-run Robitronic Mantis Off-Road Truggy. FEATURES: Chassis: Aluminum 0.12" (3mm) thick anodized red in color, with front and rear composite braces Drive: Four wheel shaft drive Engine: Axial .28 Spec 1s with...
SquareTrade © AP6.0
This is the 1/8 scale glow powered, radio controlled, ready-to-run
Robitronic Mantis Off-Road Truggy.
FEATURES: Chassis: Aluminum 0.12" (3mm) thick anodized red in color, with
front and rear composite braces
Drive: Four wheel shaft drive
Engine: Axial .28 Spec 1s with pull starter, SG (pilot) crankshaft
glow plug, slide valve carburetor, two stage foam air filter, fuel
filter
Exhaust: Polished aluminum tuned pipe w/header
Fuel Tank: 5.1oz (150cc) with flip top cap
Radio: 2-channel 27MHz AM with dual rate steering, steering and
throttle trim and reverse, high torque laydown steering servo,
charging jack on transmitter
Clutch: 3-shoe, 13 steel tooth clutch bell
Transmission: Single-speed
Ball Bearings: Full set, sealed
Shocks: Four oil-filled, with coil-over spring, hard anodized
aluminum bodied 3.5mm shafts and 14mm pistons, aluminum 0.16" (4mm)
thick shock towers
Main Gear: 52 tooth
Gearboxes: Sealed
Differentials: Bevel gear, floating front and rear diffs, ultra low
design for lower center of gravity
Brakes: Dual disk
Tires: Axial Terra-izer block pattern tread, width 2.9" (75mm),
outside diameter 5.8" (147mm), inside diameter 3.1" (80mm)
Wheels: White dish style 2.2" (56mm) wide, 3.5" (88mm) diameter, 17mm
hex
Body: Painted and trimmed truggy style with molded composite wing,
color scheme is white and red with gray and black trim
Bumpers: Front and rear composite, black in color
Suspension: Adjustable, with rubber dampened hinge pin pivot points
front and rear anti-sway bars
Caster: Adjustable, caster/toe-in refers to the angle of the front
suspension when viewed from the side of the car in relation to the
chassis
Camber: Adjustable, camber refers to the angle of the tops of the
tires from vertical when viewed from front or behind vehicle
Steering: Bushing supported bell-crank with servo saver
Warranty Period: Two year limited
INCLUDES: 1/8 scale Robitronic Mantis Off-Road Truggy, Axial .28 Spec 1s engine
glow plug, painted body, tires, foam inserts, wheels, 13 tooth
clutch bell, 52 tooth spur gear, instructions, decal sheet, 17oz
(500cc) fueler bottle, C-size glow starter, 2-ch pistol grip radio
with high torque steering servo, wrench, fuel filter, wall charger,
two extra clutch bells, extra shock spacers and servo arms
REQUIRES: 12 AA Batteries: 8 for transmitter, 4 for receiver
C-size Battery: For glow starter
Misc. Items: Tools and building equipment
Fuel: 2-cycle glow fuel with 20%-30% nitromethane, 16% lubricant-
Most of the fuels we carry meet or exceed the lubricant content
required for optimum performance and maximum engine life.
SPECS: Vehicle-
Length: 21.25" (540mm) including wing
Width: 16.3" (415mm)
Height: 6.5" (165mm)
Weight: 8.7 lbs (3935g) approx.
Wheelbase: 14" (356mm) wheels on-center front-to-rear
Front Tread: 13.4" (341mm)
Rear Tread: 14.2" (360mm) wheels on-center side-to-side
Front Track: 16" (406mm)
Rear Track: 16.7" (425mm) outer edges of wheels
Ground Clearance: 1.6" (42mm)
Tires: Width 2.9" (75mm), Outside Diameter 5.8" (147mm), Inside
Diameter 3.1" (80mm)
Body-
Length: 17" (432mm)
Width: 8.2" (208mm) in front of rear wheels (widest point)
6.1" (155mm) in front of front wheels (thinnest point)
Height: 4.5" (114mm)
Check out my other items!Be sure to add me to your favorites list!
On Jun-29-07 at 21:04:49 PDT, seller added the following information:
Use the FREE Counters 1 million sellers do - Andale!
On Jun-29-07 at 21:04:50 PDT, seller added the following information:
Use the FREE Counters 1 million sellers do - Andale!
Manufacturer: N/A
SKU: 310131266474
Sign In
